Lorex SC325000 Uživatelský manuál stáhnout pdf (Strana 41)

Connecting Alarm Device - Appendix #5

Alarm controls are enabled through the Menu system on the DVR. Additional alarm devices can

be connected to the system (Motion Sensors, Door/Window Sensors).

A motion detection or sensor unit can be used to send a signal to the DVR to begin camera

viewing on the matching Video Channel (when enabled in the MENU/ALARM SET MODE)

• Example: A Window sensor unit has been installed on Alarm Block port #1. When this sensor

is activated, ALL CAMERAS will become active (if enabled in the MENU on the DVR)

For the corresponding Menu Programming, refer to Page 26.

Installing a Sensor

1. Connect the GROUND Cable to the GND port on the Alarm Block

on the DVR

2. Connect the SIGNAL Cable to a numbered port (1-4)

DVR

SENSOR

1 2 ... 36 37 38 39 40 41 42 43 44

Žádné komentáře

Lorex SC325000 Uživatelský manuál Strana 41